interiorCAD 2.5 / VW 12 - Update for XG Units command

By HMK on February 28, 2006 11:07 AM |

Here is an update for the

  • Units - mm
  • Units - cm
  • Units - m
commands found in interiorCAD 2.5 for VectorWorks 12. These commands will properly change the primary units of the current drawing to mm, cm & m.

These commands will work in VectorWorks 12 only.

Categories:

About this Entry

This page contains a single entry by HMK published on February 28, 2006 11:07 AM.

VectorWorks and Intel-Macs was the previous entry in this blog.

Placing a unit on its back is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Links

Search