Speeding up the creation of cutting lists
The materials are read from the hard drive each time you create a cutting list. This is the reason why the creation of cutting lists needs a long time.
To cut time, you can do the following:- When recreating an existing cutting list, ensure that the checkbox »Update material« isn't enabled
- If your materials on disk don't change a lot, then it is a good idea to include the material worksheets in the interiorCAD template drawing. To do so,
- Open the interiorCAD template drawing
- Run a cutting list of a simple unit
- Remove the unit from your resource browser
- Remove the cutting lists from your resource browser
- Leave the material worksheets in the resource browser
- Save the template to your templates folder. If you name it »Default.sta« it will be loaded automatically during startup
